Microsoft Word
Before attempting to install, wire, operate and/or service the module and other electrical equipment, all instructions should be read and understood. PV module connectors pass direct
Modules can be attached using the mounting holes (2 holes of φ9×14 mm of one long-side frame, ≥ 1300 mm spacing) on the back of the module frame, by fixing the module to the support rails
module and panel are installed on a roof that must has fire-resistant degree of class A. A minimum distance of 10 cm between the roof plane and the module is generally recommended.
Installation must be carried out under the guidance of a qualified electrician. No matter the weather conditions, personnel entering the power station shall wear safety helmet, insulating
In the process of module deformation, if the junction box or glass is in contact with the obstacles below, the glass on the back will produce a large stress, and the module will have the risk of
This general manual applies to the installation, maintenance and use of the double glass solar modules manufactured by ZNSHINE PV-TECH Co.,Ltd. (hereinafter referred to as "ZNSHINE
Before installation, make sure that the connector is well protected and there should be no foreign matter such as soil, sand and gravel in the connector. If any, it must be cleaned
This guide contains information regarding the installation and safe handling of Solar- space photovoltaic module (hereafter is referred to as "module"). During Modules installation and
Before installing a solar photovoltaic system, the installer should be familiar with its mechanical and electrical requirements. The installer required relevant professional knowledge, and the
The installation of the modules shall be strictly carried out by professional technicians. Please read this manual carefully before installation.
PDF version includes complete article with source references. Suitable for printing and offline reading.